![]() ![]() The low drive current increases the LED brightness and life. The individual LEDs operate close to half of their maximum drive current even when the RL series fixture is driven at 150 Watts. The fixture is also available in a non-dimming version.īased on Cree’s product testing, The Light Source, Inc.’s RL Series fixture’s standard LED module offers over 100,000 hours of life operating from 80 to 150 input Watts. This setting allows the DMX control channel 512 to change the dimming performance to emulate a large or small incandescent lamp, or to change the dimming performance to an instant response. The Light Source proprietary Thermal Mass Equivalence may be enabled during installation by turning dip switch 1 to off. ![]() The DMX line is fully isolated to 2,500 Volts per microsecond. There is no flicker on video with either line scan or global camera shutters interacting with the 30khz output frequency. The RGBW DMX control outputs 16 bit analog on four or five channels of DMX. The dimmer microprocessor is able to use over 16 million steps from full intensity to off for incredibly smooth dimming. RL Series fixtures are fully DMX dimmable to zero with extremely smooth 24 bit dimming utilizing only single channel DMX dimming control. Optional LumenRadio wireless DMX is also available to provide control data to the fixture. DMX data connections may be hardwired with the provided IDC or screw terminal plugin connectors or the optional external flush mounted Neutrik 5 pin XLR 3 pin XLR or RJ-45 Ethercon connectors. Power connections may be hardwired internally with a ½” or ¾” conduit connections and the provided flip lever Wago connectors, or connected to an optional external flush Neutrik PowerCon connector. The annual quiescent power draw is less than 9 KWH. Standby wattage is less than 1 Watt with power on and DMX at level zero. This enables the fixtures to instantly respond to DMX control signals without waiting for relays to sequence and fixture boot time. The fixtures are fully rated for 24/7/365 operation. Relays are not required to turn The Light Source, Inc. The LED fixture responds quickly, producing full light output in 2-3 seconds after power is applied. ![]() Inrush current is limited, allowing up to 12 of the 100 Watt LED fixtures to run on a single pole 20 Amp 120VAC circuit breaker. The LED driver has active power factor correction with 99% PF at 120VAC, ATHD of 7%, and draws only. RL Series fixture’s all include the UL required thermal protector that is specific to the supply voltage. The 150 Watt LED driver may be factory preset to 80, 100, 120, or 150 Watts output. RL Series fixture’s LED driver has a universal input range of 100VAC to 277VAC 50/60HZ with no adjustments required, and a mean time between failures of 330,000 hours. The fixture is also listed for wet locations, covered ceilings for use outdoors. It is a great choice for atriums, auditoriums, churches, museums, schools, studios, theaters, and similar locations. The luminaire provides the look and feel of a natural, single source incandescent light, as well as excellent LED performance and longevity. The Light Source RL Series 2×2 6” Fresnel LED recessed fixture is perfect for applications requiring a drop-in 2’ by 2’ tile fixture with up to 12,750 lumens and excellent dimming, tight beam control, and a high quality of light. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |